Home | Leisure & Hobbies | Arts & Crafts
With stained glass, you will want to start with your design on paper. Make sure there is some definition to your design and that the differently colored areas are outlined in a darker color. You may tape your design to the bottom of your glass so that it will remain in place during painting. Begin painting the dark outlines of your design with a tracer or rigger (long brush with a slender point). You will want your trace paint to be dark enough to block out light and provide contrast with your lighter colors. You must apply the outlines in long, smooth, continuous strokes. Do not try to "go over" your lines once they have dried (which does not take long!). There are many techniques that can be used to create beautiful and interesting works of art in stained glass. This article deals with stained glass painting. This technique has been used for centuries and was the most popular form of stained glass during the Renaissance era due to their keen aspiration for intricate details in artwork. Painting of stained glass became so popular, in fact, that the earlier stained glass arts of using "pot metal glass" almost disappeared entirely. If you do you will cause the paint to bubble and separate (fry) when the glass is fired in the kiln. You should not touch the line at all once it has been painted, although you may correct some mistakes and overages by gently scraping the paint off with a toothpick AFTER it has dried completely. Next, your stained glass trace paint is fired in the kiln at approximately 1150? F. Stained glass paint is a high-fired permanent paint which actually has glass (called the vehicle) in it. Stained glass paint also contains lead and has coloring agents like sand, alumina, clay, red or white lead oxide, boric acid, potassium and sodium. The lead in the stained glass paint refracts light. The matt (paint) can be applied, taken out in the tracing, fired, and then applied again, depending on the lighting, detail, and textures you want to achieve in your stained glass painting. Your skill and technique in painting stained glass will improve over time, as with any new endeavor. Be patient and allow yourself to enjoy the process. Painting stained glass can be a rewarding hobby and with a little practice you may even create a masterpiece someday! Workshop safety tips When carrying sheets of stained glass, wear gloves that help you have a good grip on the glass. The gloves should protect your hands from cuts from the razor sharp edges of the stained glass. Grip the glass on each side. Carrying it with one hand on top and one on bottom creates a hazard that the glass could snap in two. If you grip from each side and the sheet of stained glass breaks, you have a better chance of letting the glass slip away from you without being cut. Never use a glass grinder without protecting your eyes. Glass particles can fly up into your eyes and cause terrible pain and may permanently damage your eyes. Most glass grinders are equipped with face shields or face shields can be purchased separately. Make sure that your area is well ventilated when you are soldering. Fumes from solder and flux contain harmful lead and acid. Solder scraps should be kept in a special container for taking to a recycler. Common sense and a clean stained glass workshop will help keep you safe and add to your enjoyment of the art of stained glass.
Provided by ArticleGOLD: Articles Directory - Article Directory
About the Article Author
If you want to access more information on products worth investing on, visit the following link: New Product Development.
Please Rate this Article
5 out of 54 out of 53 out of 52 out of 51 out of 5
Not yet Rated
